Remote-Control CommandsGPS and Assisted GPS
75Operating Manual 1171.5248.12 ─ 15
Determines the duration of the satellite simulation.
The resulting duration of the simulation is calculated as follow:
Duration of Simulation = [Duration of Satellite Simulation /(1±Doppler Shift/F
L1orL2
)
where F
L1 or L2
is the frequency selected with the command BB:GPS:RFB.
The maximum duration depends on the Oversampling factor (BB:GPS:FILT:OSAM) and
the ARB memory size of the connected instrument.
Parameters:
<Duration> float
Range: 20ms to 132s
Increment: 20ms
*RST: 20ms
Example:
BB:GPS:DUR 1.2s
selects a duration of 1,2 sec.
[:
SOURce<hw>]:BB:GPS:BAB[:STATe] <State>
Note: This parameter is available only in path A of two path instruments.
Enables/disables control of both paths via the GPS menu of path A.
If this parameter is enabled, a total number of eight satellites can be configured.
Note: Configuration of eight satellites is only possible for two path instruments.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: OFF
Example:
BB:GPS:BAB:STAT ON
Enables control of both paths via the GPS menu of path A. 8 Sat-
ellites can be configured.
[:SOURce<hw>]:BB:GPS:LMODe <Lmode>
(R&S SMx/AMU instruments only)
Sets the localization mode.
Primary Settings
Commentaires sur ces manuels