Case K44 Spécifications Page 37

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 165
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 36
IntroductionGPS and Assisted GPS
23Operating Manual 1171.5248.12 ─ 15
2. Enable the instrument to work in "Localization Mode Auto SV Selection".
Note: Do not use the "Auto SV Selection and Update" mode for the generation of A-
GPS test signals.
3. Select "Full Configuration" mode.
4. Select the "Satellite Configuration" and reconfigure the satellites' parameters as
required.
5. Configure the "Navigation Message" and for instance adjust the ionospheric model
per satellite.
6. Set the GPS "State" to ON to enable the GPS signal generation.
7. Generate the required "Assistance Data".
The R&S Signal Generator generates an A-GPS signal according to the settings
made.
2.8.6 Generating A-GPS Test Signal
(for R&S SMx/AMU instruments equipped with option Assisted GPS (R&S-K65) only)
The generic workflow for generation of A-GPS test scenarios in conformance to A-GPS
2G/3G Protocol and Conformance Test Cases is as follow:
1. Execute "Set To Default" to adjust the instrument's settings to a standard set of oper-
ating conditions.
2. Select a predefined GSM or 3GPP FDD "AGPS Test Scenario".
3. Set the GPS "State" to ON to enable the GPS signal generation.
The R&S Signal Generator generates an A-GPS signal according to the selected test
scenario.
2.8.7 Generating Assistance Data
(for R&S SMx/AMU instruments equipped with option Assisted GPS (R&S-K65) only)
The generic workflow for generation of assistance data files for A-GPS test scenarios is
as follow:
1. Execute "Set To Default" to adjust the instrument's settings to a standard set of oper-
ating conditions.
2. Enable the instrument to work in "Localization Mode Auto SV Selection".
Note: Do not use the "Auto SV Selection and Update" mode for the generation of A-
GPS test signals.
3. Enable the instrument to work in "Full Configuration" mode.
4. Set the GPS "State" to ON to enable the GPS signal generation.
Typical Workflows
Vue de la page 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 164 165

Commentaires sur ces manuels

Pas de commentaire