Case K44 Spécifications télécharger pdf (Page 152)

Remote-Control CommandsGPS and Assisted GPS

138Operating Manual 1171.5248.12 ─ 15

The marker delay settings are available for R&S SMx and R&S AMU instruments only.

OUTPut<ch>

The numeric suffix to OUTPut distinguishes between the available markers.

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut:DELay:FIXed..................................................138

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut<ch>:DELay....................................................138

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut<ch>:DELay:MAXimum....................................139

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut<ch>:DELay:MINimum.....................................139

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut<ch>:MODE....................................................139

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut<ch>:ONTime..................................................140

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut<ch>:OFFTime................................................140

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut<ch>:PATTern.................................................141

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut<ch>:PULSe:DIVider........................................141

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut<ch>:PULSe:FREQuency.................................141

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut<ch>:PULSe:WIDTh.........................................142

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut:DELay:FIXed <Fixed>

Restricts the marker delay setting range to the dynamic range. In this range the delay

can be set without restarting the marker and signal. If a delay is entered in setting ON

but is outside this range, the maximum possible delay is set and an error message is

generated.

Parameters:

<Fixed> 0 | 1 | OFF | ON

*RST: OFF

Example:

BB:GPS:TRIG:OUTP:DEL:FIX ON

restricts the marker signal delay setting range to the dynamic

range.

[:SOURce<hw>]:BB:GPS:TRIGger:OUTPut<ch>:DELay <Delay>

Defines the delay between the signal on the marker outputs and the start of the signal,

expressed in terms of chips. Command :BB:GPS:TRIGger:OUTPut:DELay:FIXed

can be used to restrict the range of values to the dynamic range, i.e. the range within

which a delay of the marker signals can be set without restarting the marker and signal.

Parameters:

<Delay> float

Range: 0 to 2^32 - 1 chips

Increment: 1 chip

*RST: 0

Example:

BB:GPS:TRIG:OUTP2:DEL 1600

sets a delay of 1600 chips for the signal on connector MARKER

Marker Settings

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 164 165

Pas de commentaire

Case K44 Spécifications Page 152